Пропан .Ру

Мне нужно .hex и .dat файлы для етот компютер,так что могу внести коррекции в настройки?
https://yadi.sk/i/NcOzQA_YuLfNZ

connect plus 2010 and show the start screen

OK.But on 2010 almost everywhere writes "not available".

one might also like these

Эту программу пробовали!
http://www.stara.landi.pl/download/LPG_GM_403V.EXE

Добавлено через 40 минут 14 секунд:
Можно попробовать обновления для Les Plus 4.03

firmware update involve the loss of all shortcuts to other opel ecu
if a firmware update with new calibration desire then equal Plusmax to HW3 with included injektortest
Change the operating system is always a risk better continue working on existing system
screen video
http://sendvid.com/jbzjavyl

When customers come again, I will do video with PlusMax2010.
For me no problem to kill computer,when not working properly!

Hi,can I programming this Ecu by PlusMax or Omegas? I tried connect Plusmax but no connect. Omegas do connect but no luck with corections...
Opel Astra H , 1.6. 2007
Thank you for answer.

Check sensor for water temperature

]

Thank you. How do car know when switch to gas, if is temperature sensor show 0. Customer tell me: when the car switch from fuel to gas then fault light on dashboard comes on but car have little jerks and run on gas. I just read fault code memory with omegas and there was fault with 2 injectors and in car ECU been 4 cylinder missfire. I don´t have car on garage yet to check temp. sensor. Sorry for my english. Thank you again.

Posted after 18 hours 10 minutes 36 seconds:
Where do I find software OmegasReader on pic above?

atcservis писал(а):Where do I find software OmegasReader on pic above?

I made this program, it is alternative tool for Omegas ECU 3-4 cyl. and 5-6-8cyl.
for example for 3-4cul. COD. 616264001, 616267000

You can get this only from me, just write PM.
The program is in Polish, but partially translated to English too.

Hello, can I get OP202043G34 open fw? I need to do remap after been cange MED blue injectors.
Thank you