soglaev писал(а):у брс температурная коррекция не реализована.
холодные стратегии вкладка в управляемости.
5.2.2.1.5.3 Cold strategy
Cold strategies allow setting up specific values of tip-in leaning or enrichment in case of low temperatures.
Usually, tip-in should be more leaned in case of cold.
Calibration software enters default values with leanings higher than the tip-in ones in warm condition. If installer
changes the warm default values (Tip-in) without changing the cold ones, these latter changes consequently so that
a constant difference is assured.
If installer manually enters a cold correction value different from the default one, the system does not change it
anymore.
This page is very similar to the tip-in one, showing the same cursors mentioned above.Moreover, there are two numerical boxes that can be set up:
Low Temperature Threshold [C°]: under this ECT, tip-in and tip-out corrections are the ones indicated in this page
and not in the tip-in one.
High Temperature Threshold [C°]: over this ECT, tip-in and tip-out corrections of this page are ignored in favour of
the tip-in page ones.
Please remember that in case of temperatures included between these two thresholds, correction values used by
the system are the intermediated ones between this page and the tip-in one. The closer the temperature to the low
threshold, the closer the values to the first ones; the closer the temperature to the high threshold, the closer the
values to the second ones.
Parameters section shows the current ECT.
Delta Flow [%] parameter shows the real tip-in condition.
У вас нет необходимых прав для просмотра вложений в этом сообщении.